Door locking problems almost always originate in the door latch not the locking mechanism.
Mb front door handle light always on after door closed.
Apply wd 40 or equivalent product directly into the lock.
The striker fails to penetrate into the door jamb because the door.
Parked it on friday went out to find the door ajar light on saturday morning.
If a door unlocks but will not lock again then replace the door switch.
When you come in kick the door shut wash your hands then lock the door a us doctor advises.
It turns out that i had a very easy one this time.
I heated the shop to perform a 20k maintenance on the car which thawed the car out for the first time in a couple months.
Well in that case if trying to clean unsticking the door lock actuator and then spraying with some white lithium grease and still won t free up the inside door panel will have to be removed i am pretty sure you will have to drill out the rivets on the inside to access the actuator then put 4mm or 5mm screws back on it when finished there are several electrical plugs you can t see until the.
After reading this thread i decided to swap out the plunger courtesy switch on the driver s side.
How to fix a door that will not lock.
Source istock when it comes to taking extra hygiene precautions you can never be too safe.
You likely have a shorted door lock actuator which you can replace with a new unit for the lock that is not working.
I had the same issue with my 2002 tundra.
The sensor typically uses a switch with a spring loaded plunger that is compressed when the door is closed and is released when the door is open.
It caused ice between the door seal and the door to melt and subsequently refreeze once the car went outside essentially freezing the door closed.
Open and close lock to recalibrate.
This action opens and closes an electrical circuit sending a signal to your vehicle s computer activating the door ajar warning light when the door is open.