Plug the washer back in and hopefully the board reset.
Maytag maxima washer door locked flashing.
When using one of these cycles the door will remain locked until the cancel button is pushed.
Run a drain and spin cycle.
The top panel will then pull straight back up and off.
Pull on this tab to manually unlock the door.
Our maytag maxima steam washer has a flashing yellow light next to door locked the door won t open and the machined cannot be turned on.
This is all it will do.
The washer will go into a hold and drain routine for 8 minutes.
Check door lock mechanism for damage misalignment or foreign objects.
Now you can reach down to the bottom of the door latch where there is a 1 round plastic tab.
This happened when i forgot to turn the water on.
After 8 minutes the door will unlock.
If not then your main control board will need to be replaced.
Door not completely closed due to interference.
At the start of a cycle the washer attempts to lock the door 6 times.
Pausing the wash cycle is how it can be disabled.
If the washer will not unlock at the end of a wash cycle unplug the washer or disconnect power.
During this period you will be able to hear the pump running.
Wait approximately 2 minutes for control to reset.
The lid lock is a default feature of your maytag front loading and top loading washer to prevent opening the appliance while the cleaning cycle is in progress.
The door should unlock after 60 seconds.
It stopped right after it dispensed the detergent and i ve tried all of the not so helpful repair advise on the maytag website and i still can t get it unlocked.
I noticed that my maytag maxim front load washer was flashing door lock and error code f6e1 i think along with annoying chimes or buzzing.
A lock icon appears on the front of the washer s control panel to indicate the lid is locked and also displays the current progress of the cleaning cycle depending on the model of your maytag washer.
Reconnect power to washer plug in.
First it had a code blinking that i looked up and it was for the water so i turned it on and now it is making a humming noise and the door is locked and that is all it will do.
Nothing else will appear to be happening with the machine during this time.
If door cannot be locked the washer goes into pause mode and a code is generated.
