The ice maker will continue to try to make ice causing a buzzing sound.
Maytag french door ice maker not working.
When the ice maker heater is on the test will disply onh.
Refrigerator ice dispenser not working.
Door parts drawer parts drip bowl drip pan parts duct venting parts fastener parts filter parts fuse.
Check to make sure the ice maker is turned on.
The icemaker isn t making enough ice.
Next fill up the icemaker with a cup of water and wait 24 hours to see if it cycles and dumps the ice.
Verify that the ice maker is turned on.
10 possible causes and potential solutions.
Do you have the correct water pressure.
The freezer temperature should be set between 0 and 5 degrees fahrenheit 18 to 15c for the ice maker to work properly.
If your refrigerator was just installed it may take 24 hours for ice production to begin and up to three days for full ice production.
Check that the ice cubes are not jammed in the chute.
Discard any ice in the area that is jamming up the chute.
For instructions on turning the ice maker on and off please see reference the owner s manual.
If a large amount was recently removed it could take 24 hours to fully replenish.
A standard icemaker should produce about three pounds of ice a day.
Test the ice maker dispenser about one hour after removing all the jammed ice cubes.
First make sure the freezer is below 10 degrees because the icemaker will not cycle if the temperature in the freezer is over 10 degrees.
Unjam the ice maker chute.
Service test 192 display shows the status of the ice maker the heater on or off when left fresh food door is open the ice maker cannot be energized the test will display dr indicating an open fresh food door.
If the ice maker s water supply is not connected to water supply line turn the ice maker off.
If the ice maker is on but disconnected to water supply line the following could happen.
Hollow or small ice cubes along with slow or no water dispensing is likely due to low water pressure.
A refrigerator section may to be too cold.
Maytag refrigerator repair help.
Check for clumping near the ice ejector arm or auger.